Research Tools
Dosage Calculator
Select a peptide from the catalogue or enter your own values. The calculator works out your draw volume in units and estimates how many vials a research protocol may require based on the parameters entered.
0 of 4 complete
1
Vial setup
Not set
Selecting a product pre-fills common reference dose ranges.
Used for labelling the result only.
mL of bacteriostatic water used to reconstitute the vial.
2
Syringe type
Not set
U-100 insulin syringes are the standard for peptide research. The 1 mL barrel (100 units) is the most common.
3
Dose per injection
Not set
Amount per injection. Enter any value.
How often per week.
Length of the main protocol phase.
Optional
Titration (ramp-up) phase
Start at a lower dose and increase gradually before reaching the main dose.
First injection dose.
Weeks to ramp up to the main dose.
How the dose increases each week.
Optional
Taper (ramp-down) phase
Reduce the dose gradually at the end of the protocol rather than stopping abruptly.
Last injection dose before stopping.
Weeks to reduce from main dose to final taper dose.
Results
Concentration
—
mcg / mL
Main dose draw
—
units (U-100)
Draw volume
—
mL
Total protocol
—
weeks
Week-by-week protocol schedule
| Week | Phase | Dose / injection | Draw (units / mL) | Draw (mL) | Cumulative mg |
|---|
Estimated vials for full protocol
—
Complete the form above to calculate
Not sure how much BAC water to add or which syringe to use? The Reconstitution Calculator covers the mixing process step by step.
Reconstitution Guide →
Looking for a pre-built multi-compound protocol with a visual timeline? The Stack Builder has curated stacks with titration and taper phases already mapped out.
Stack Builder →
Research use only. This calculator is provided for reference purposes. Values are estimates based on the parameters entered. All PEPNERD products are sold strictly for in-vitro scientific research and are not intended for human or veterinary use. Consult the relevant literature for compound-specific guidance.